Google Nest Learning Thermostat (4th gen) wiring for 2-stage heat + 2-stage cool

Good news: the Google Nest Learning Thermostat (4th gen) is a direct swap for this setup. Every wire has a matching terminal.

W2 and Y2 mean a two-stage furnace and a two-stage AC. They run on low most of the time and step up on extreme days. Budget thermostats can’t run the second stages.

1Snap a photo of your old thermostat’s wires (optional)

📷 Upload or take a photo

AI reads the terminal letters and wire colors, then you double-check them. Photos are not saved.

2Tick every terminal that has a wire

Pull the faceplate off your old thermostat. Use the letter printed next to each wire, not its color. Skip short jumper wires between two terminals.

More labels (W3, X, X2, K, PEK, L, S, T, U, HUM, DEHUM)

3A few quick questions

Do you have a heat pump?

YesNoNot sure

A heat pump is an outdoor unit that both heats and cools. Heat pump thermostats usually have an “EM HEAT” or “AUX” setting.

Do any of these apply? Thick wires joined with wire nuts, 120/240 V labels, or electric baseboard heaters (line voltage) Gas wall/floor heater or fireplace that runs without household power (millivolt) Numbered terminals (1, 2, 3, 4 or A, B, C, D), e.g. Carrier Infinity or Lennox iComfort

4Your wiring

Your system: 2-stage heat, 2-stage cooling, fan, C wire present · 7 wires

Which smart thermostats work with your wires?

Google Nest Learning Thermostat (4th gen)

Works: direct swap

Wire	Color	Job	Connect to	Note
R	red	24 V power	Rc or Rh
C	blue	Common (C wire)	C
W1	white	Heat, stage 1	W
W2	brown	Heat, stage 2	W2
Y1	yellow	Cooling, stage 1	Y
Y2	orange	Cooling, stage 2	Y2
G	green	Fan	G

Install steps

Turn off power to the furnace/air handler (switch or breaker) and the AC condenser. Confirm the old thermostat is dead.
Photograph the old wiring, then label each wire with the letter it came off. Ignore short jumpers.
Connect each wire to the Nest Learning (4th gen) terminal shown above. Cap unused wires one at a time.
Restore power and finish setup in the app using the settings below.
Test heat, cool and fan. If a breaker trips or equipment runs nonstop, power off and call a pro.

App settings to choose

Set the number of heat and cool stages to match the wires connected.
Single R wire: the Nest app tells you whether to use Rc or Rh.

What you need

Google Nest Learning Thermostat (4th gen)The thermostat itselfCheck price

As an Amazon Associate we earn from qualifying purchases, at no cost to you.

Confirm against the official Google Nest install guide. The app also checks your wiring during setup.

Frequently asked questions

Where does each wire go on the Nest Learning (4th gen)?

R → Rc or Rh; C → C; W1 → W; W2 → W2; Y1 → Y; Y2 → Y2; G → G.

Do I need a C wire for the Nest Learning (4th gen)?

You already have a C wire, so no adapter is needed.

Other thermostats for this setup

Nest Learning (4th gen): other setups